Looking at a Automag Pump for sale on Ebay

[birdinator]

Remember to remove the shims from the Level X and to keep the same oring when changing carriers. The different size carriers is to compensate for the inconsistency of the o-rings.

Did that and the bolt stick has gone away by installed the the shortest brass shim (no lines/one dot.) But now I get a leak down the barral. Goes away when I pull and hold the trigger. Am I correct in thinking that now I need to move to the next size up of brass shim?

One thing I noticed is that besideds the brass shim, there is also one thin metal washer like shim. I also have a few extra that came with the gun. Would I use them to solve this issue also going from one to two of these shims?

Thanks for the help.

[OPBN]

Did that and the bolt stick has gone away by installed the the shortest brass shim (no lines/one dot.) But now I get a leak down the barral. Goes away when I pull and hold the trigger. Am I correct in thinking that now I need to move to the next size up of brass shim?

One thing I noticed is that besideds the brass shim, there is also one thin metal washer like shim. I also have a few extra that came with the gun. Would I use them to solve this issue also going from one to two of these shims?

Thanks for the help.

The thin metal shims are Level X shims. Take them all out and see how it does. You may have to try going back up a size with the shims out. Also remember oil is your friend.

[birdinator]

The thin metal shims are Level X shims. Take them all out and see how it does. You may have to try going back up a size with the shims out. Also remember oil is your friend.

I have what looks like the same shims in the on/off assembly. Should I remove those also?

And should I be posting this up in the tect forum?

[OPBN]

I have what looks like the same shims in the on/off assembly. Should I remove those also?

And should I be posting this up in the tect forum?

You shouldnt have to remove the ULT shims to tune the levelX. You should remove the detent though.

[Ando]

I have what looks like the same shims in the on/off assembly. Should I remove those also?

And should I be posting this up in the tect forum?

Don't mix up those shims. The lvl 10 and ULT shims are different thicknesses.

[birdinator]

Don't mix up those shims. The lvl 10 and ULT shims are different thicknesses.

So I got the leak to stop and it shoot perfect. Thanks for the help.
The only one issue I have left is that when I air up the gun, it fires once.
How can I do a search in the tect forum too find a solution to this issue?

[AO Moderation Team]

And should I be posting this up in the tect forum?

Yes

[sQuidvision]

So I got the leak to stop and it shoot perfect. Thanks for the help.
The only one issue I have left is that when I air up the gun, it firs once.
How can I do a seach in the tect forum too find a solution to this issue?

my ULT does this as well... ive always been told its 'normal'

[need4reebs]

So I got the leak to stop and it shoot perfect. Thanks for the help.
The only one issue I have left is that when I air up the gun, it firs once.
How can I do a seach in the tect forum too find a solution to this issue?

try pulling the trigger and holding it while airing up your Mag...helps to get everything seated?

[birdinator]

try pulling the trigger and holding it while airing up your Mag...helps to get everything seated?

I will try it tonight and also look at how much play I have between the trigger and the sear pin.