Ideas for lasering on the triple

[knownothingmags]

no problem, im just greatfull for the help.

thankyou,
Ryan M.

[Flatliner333]

[RST]

For me, we have a winner!

[Maghog]

Nice work Bunny, really. Those are simple and effective designs.

[Spider-TW]

Nice work Bunny, really. Those are simple and effective designs.

I know they will look better, but I was still hoping for the three-headed giant from Monty Python's Holy Grail.

[BTAutoMag]

I know they will look better, but I was still hoping for the three-headed giant from Monty Python's Holy Grail.

Why not the bunny?

[knownothingmags]

oooooh i like that.

[Spider-TW]

Why not the bunny?

Only because it has two, big, nasty teeth! (not three)

[knownothingmags]

the valves are back to me finally

so i have come to a conclusion, that i am just going to keep the hole gun dust black, and the valves will be the only thing that will get lasered at this time.

but yeah i have the valves in hand, just need to get a final design decided upon.

thankyou to everyone who has been involved so far.

[Justus]

Did you decide on who's doing the lasering?

[knownothingmags]

Did you decide on who's doing the lasering?

the only people i know of at this moment is LMG, laser my gun.

so they are my best option right now.

but if there is a by far better option i am definently open to suggestions.

thankyou,
KNM.

[Flatliner333]

If you go with LMG get with Dan, he will take good care of you .

[knownothingmags]

If you go with LMG get with Dan, he will take good care of you .

i will make sure to make a note of that.

ive said it before somewhere and ill say it again, i need all the help i get get, i am outside of my realm on this.

thankyou so much everyone,
KNM.

[Bunny]

Flatliner333's Design:

[knownothingmags]

Flatliner333's Design:

i like it.

where should i get it lasered on each valve 9, 10, 10.5, 11 oclock?