no problem, im just greatfull for the help.
thankyou,
Ryan M.
no problem, im just greatfull for the help.
thankyou,
Ryan M.
Originally Posted by Tropical Life
For me, we have a winner!
Nice work Bunny, really. Those are simple and effective designs.
I know they will look better, but I was still hoping for the three-headed giant from Monty Python's Holy Grail.Originally Posted by Maghog
Why not the bunny?Originally Posted by Spider-TW
oooooh i like that.Originally Posted by Flatliner333
Only because it has two, big, nasty teeth! (not three)Originally Posted by BTAutoMag
the valves are back to me finally
so i have come to a conclusion, that i am just going to keep the hole gun dust black, and the valves will be the only thing that will get lasered at this time.
but yeah i have the valves in hand, just need to get a final design decided upon.
thankyou to everyone who has been involved so far.
Did you decide on who's doing the lasering?
the only people i know of at this moment is LMG, laser my gun.Originally Posted by Justus
so they are my best option right now.
but if there is a by far better option i am definently open to suggestions.
thankyou,
KNM.
If you go with LMG get with Dan, he will take good care of you .
i will make sure to make a note of that.Originally Posted by Flatliner333
ive said it before somewhere and ill say it again, i need all the help i get get, i am outside of my realm on this.
thankyou so much everyone,
KNM.
Flatliner333's Design:
i like it.Originally Posted by Bunny
where should i get it lasered on each valve 9, 10, 10.5, 11 oclock?
And this...I think I like the bottom one best or bunnies.
Last edited by Flatliner333; 12-07-2012 at 02:32 PM.
Remember whatever you go with you have to convert it to Vector form then invert the colors before you submit it. The laser turns the black areas white and leaves the white areas black so it needs to be the opposite of what you want it to end up.
what about a 3 fingered claw ripping through the valve with XXX in the rip
yeah ive been getting those details handled. bunny has alot of this under controlOriginally Posted by Flatliner333
Originally Posted by knownothingmags
We're all gonna die!
KNM: Still working on it!! Hopefully I'll get some time to finish up the design. Since I always like to post a picture with my posts...
thats awsome.Originally Posted by Bunny
are those oil jugs as hoppers?
since PBpixels is a busy man,
i think we are going with just the blank valves with the warnings and serials.
so now just to find someone who wont screw the lasering up.
knownothingmags: I can still help you out if need be. These past few weeks have been hectic. Gotta love the holidays
I would suggest finding a local laser engraving company and have them laser engrave a test piece. Just to make sure you like the way the fonts come out. I would hate to see you having to re-anodize the valves again.