After all these years I have a question about Micromags...

[Frizzle Fry]

Is the Micro2000 feedneck press fit? Or is it a true unibody? Never thought to mess with one.

[SSP REAPER]

Feedneck is press fit and yes it is a true unibody

[cougar20th]

It is a true unibody

My understanding is that a very few of those had a threaded feedneck from PTP. But the overwhelming majority where press fit.

[Frizzle Fry]

Feedneck is press fit and yes it is a true unibody

D'oh, I sometimes forget (since most of my Automags are Micros or Xmags) that in the autococker world, "unibody" means that the feedneck stem is milled out of the same block of aluminum and then threaded, as opposed to being pressed in or threaded in.

It is a true unibody

My understanding is that a very few of those had a threaded feedneck from PTP. But the overwhelming majority where press fit.

I have one of the 10 that is threaded. I was given to understand that they were slated for the 2004 MicroPneumag project.

Thanks for the help guys, it explains a lot about a recent ano project.

[SSP REAPER]

That's what we are here for

Now... PICS