OldPBNoob
I have an olders Palmers LPR that I was trying to set up to test a Pneu setup and having some leak issues. First it is leaking out of the fitting side that screws into the LPR. Should I be using thread tape on this? Also, as I am screwing the adjustment screw in, it seems to start leaking slightly out of the screw. Is this normal?
Of course it works-its AGD
You shouldn't use tape on any air fittings that feed an area where there are moving surfaces that need a good seal. Any piece of tape that breaks off will cause inconsistent operation and over-pressure issues. Always use high pressure thread sealer (not thread locker).
It shouldn't be leaking through the adjustment screw. There is probably a piece of dirt in there somewhere.
Except for the Automag in front, its usually the man behind the equipment that counts.
Posting Permissions
Reply With Quote