like always thankyou again to everyone for all the help. and advice over the past few years.
finally found something I love to collect.
I have to change my pants a second time!
Make a quad Xmag!
I am sick. That stuff is MINE! Woe is me! I have to be CRAZY!
RKM 3D Designs
I have 6 New Black ULE Xmag frames in stock. I will figure out the pricing on these tomorrow. Get them while you can boys. Only a few left.
I need 4 frames.
one of these needs to have a DNA board...
though a double Xmag fed off one warpfeed would be hella cool. like in the "rufus" area of coolness.
im trying to design something that I can print on my 3D printer.
so that I can feed double or triple or more mag with on warp hose, and have the housing "ratchet" persay quite fast so all breaches are full each shot.
and with antilock mechanism per say that will keep it from crushing balls.
If you find that you don't need all four Xmag bodies I'd be happy to help your out
You going to do a sleeper pnuemag with one of those bodies and frames? You can even run try to run all the lines in the frame into the valve.
let me know if that pbx body needs a new home. mine gets lonely.
yeah I bet,
after I sold the last three markers im kinda disappointed that I did,
so I probably wont let any of my stuff go anywhere.
still have a phoenix body and rail and ripper body and rail coming from xmt.
then onto the pneutriple mag, details on that as they come.
found out that my actuator coupling wont cycle all 3 valves at the same time,
and since they are at 45* angles on the outside its tough to have the three valves cycle independently and at the same time "mechanically"
no worries it will be worked out. (thanks to need4reebs)