Installing shims in the Level 10

**BlackVCG** · 08-19-2002, 09:07 PM

To make sure you have it in all the way, measure from the tip of the bolt to the back of the bolt piston (piece that sticks out the back of the bolt). The length should be 2.010"

The next batch will be machined as one piece.

**Midway** · 08-21-2002, 08:09 AM

Piston Problems

When the next batch comes out machined as one unit will there be an opportunity for us early pioneers to upgrade to the new bolt?

**Pand0ra** · 08-22-2002, 05:14 AM

I had also the problem with the piston. And I've a removable power tube too lol.

Is red loctite not a bit too strong for this job? It'll be almost impossible to unscrew the two parts if one day it's needed.

@++

**BlackVCG** · 08-23-2002, 09:30 AM

You will NEVER need to unscrew the PT to service anything. AGD welds them from the factory. There is no reason to take it apart so yes, red loctite is suitable in this situation.

**Pand0ra** · 08-29-2002, 05:56 AM

Okidoki. PT tube redloctited :) .

**warpfeedmod** · 08-29-2002, 07:09 AM

how do I know if I've got an older LV10 with the piston that comes out? I just got my kit about a month ago or so.

**Pand0ra** · 08-29-2002, 07:28 AM

The first batch of bolt was made with a two parts piston.

I don't think the piston in one part is already available.

@++

**warpfeedmod** · 08-30-2002, 06:09 AM

doh okay I'll have to be careful with it then I guess..I havn't tried to see if it'll come apart

Installing shims in the Level 10

Comment

Comment

Comment

Comment

Comment

Comment

Comment

Comment