Registered User
Hello AO,
I am wondering if a Geo feed neck (pictured) will fit over the my classic body's feed neck? (Vertically modded, but the diameter hasn't changed)
If not, are there any recommendation for attaching hopper to this body? I have been using the plastic vertical feed neck but those make the hopper too tall.
Thanks for the great support, AO!
O.F.P.P.A. Member
Try one of these:
Lapco Clamping Feed Neck
Walker
O.F.P.P.A. - OLD FARTS PAINTBALL PLAYERS ASSOCIATION
When you wrap-up the day with beer and Bengay.
Registered User
Thanks for the rec!Originally Posted by Walker
if the lapco feednecks are out of stock, you can also get one from palmers.
Registered User
Awesome, that gives me an alternative to work with. Thanks!
www.BigEvilOnline.com
If anything it will be a little too big, not too tight. Add a few orings or some tape to take up the slack if it's loose.
OldPBNoob
Those Palmers ones look nice. Might have to get rid of my Redz one for one of those.
Of course it works-its AGD
All I can say is "Probably". Most straight, non-threaded feednecks are 7/8", which is the same as the automag.Hello AO,
I am wondering if a Geo feed neck (pictured) will fit over the my classic body's feed neck? (Vertically modded, but the diameter hasn't changed)
Except for the Automag in front, its usually the man behind the equipment that counts.
AKA Menace
One of the Empire versions will fit. Think it might be the Axe/Mini version that also contains the threaded body adapter, which is ~same OD as the feed tube. Don't quote me on it being this model. I think it is, but cannot be certain. But either way, I saw it go straight out of the box and right onto the mag feedneck tubing. Fit snug, was easily tightened, and looked pretty decent.
I also like that it's a lever lock. If only LAPCO made one of those . . . .
Posting Permissions
Reply With Quote