warp with highrise

[frost]

i have a emag high rise vertfeed body on my automg and i will have a warpfeed coming my way soon. now my question is (it may sound dumb) but is my vert feed to high for the warpfeed to feeed the balls up there?

[danheneise]

nope it will work just fine, the warp will feed as long as the hose is, just might look a tad bit weird with a highrise but your probably kinda stuck with it

[bmexline]

or you could just buy my no rise that i have for sale :D

[jayloo]

For about $65-$80 u can get a warp e-mag body used here in AO.

[xen_100]

you can do one of two things if the hose is too long, or if it just looks goofy.

1) buy a warp body

2) cut the high rise off your exsisting body and this will allow the warp to mount flush with the body. I did this on my spyder (http://spyder.xenpb.com), looks great

[sneakyhacker420]

chop down the vert feed tube (cut off the feed cup) and then just use the clear 90º elbow and slip it over the remaining stub of the vert feed

low-profile and looks clean


and when you dont want the warp anymore, you can slip a revvy over it and hose clamp it in place - voila! insant no-rise :p