View Full Version : how can u make the feed tube lower?
laxster08
09-10-2003, 07:07 PM
ok i got the classic mag... http://store.yahoo.com/actionvillage/010-1000.html ...and the feed tube is freakin huge..and hwne i putt on my hopper and elbow on everyoen can see me from behind a baracade...so is there n e way i can make is smaller>???? thanks guys..and how low can it go if i can make it smaller...thanks
Evil Bob
09-10-2003, 07:24 PM
Say "hello" to Mr. Hacksaw...
-Evil Bob
the_next_guy_
09-10-2003, 09:06 PM
one of those pipe cutters that looks like a vice clamp.
GoatBoy
09-10-2003, 09:57 PM
Originally posted by Evil Bob
Say "hello" to Mr. Hacksaw...
-Evil Bob
Uhm, ok. But why am I saying 'hello' to this guy?
http://www.hacksawjimduggan.com/images/bikerscourt4.jpg
Jack & Coke
09-10-2003, 10:12 PM
I used a die grinder and a cutting disc like this one...
http://www.wolfsburgwest.com/wired/wired_04_02/pan%20removal%207.jpg
dinger
09-10-2003, 10:14 PM
LMAO
thats hilarious
and btw, you can use a dremel to cut it off, or use a hacksaw [as mentioned above], or if you got the time you can sand it the whole way down lol
just make sure you have enough feedneck left for your elb0w :o
Madhatter
09-10-2003, 11:47 PM
Get a ULE body.
or perhaps a warp feed.
FreakBaller12
09-11-2003, 11:08 AM
trust me i fixed up my centerfeed the other day
use a pipe cutter they will give you the straightest cleanest cut you can get
GoatBoy
09-29-2003, 12:12 AM
Alright, all comedy aside...
I was looking at some pipe cutters at the hardware store today (the kind that look like vise clamps), and it didn't look like they were really strong enough to cut the stainless steel of a mag body.
Is there some specific brand or something I should be looking for?
speedyejl
09-29-2003, 02:34 AM
Get a dremel tool, best thing you can buy for paintball tinkering
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.