minimag leaking...need help

[magman234]

my retro valved minimag is leaking out the barrel pretty heavily....what can i do to remedy the problem?? thanks ahead of time for the help.

[Dayspring]

Level 10?

Does the leak stop when you pull & hold the trigger?

[magman234]

yes, i have lvl 10 and i know what you mean by holding the trigger down...its not like that....it leaks constantly out the barrel and adjusting the velocity and rapid burst firing didnt help it either. i had 4400 psi i my tank and i have shot about 200 balls and its down to 1300.

[Dayspring]

How new is the level 10? How many cases have you shot through it?

[penguinpunk555]

did u oil the power tube make sure u oil ur power tube what kinda air r u using? pm g'off he fixes my mag all the time

[sneakyhacker420]

if its leaking down the barrel, make sure you have the delrin spacer in the bottom of the PT, then the spacer with the o-ring side facing down, and make sure that your carrier fits the bolt right and that the o-ring is lubricated with oil and is not cracked, torn, or damaged in any way



also, make sure that you are using the LX powertube tip

[jungleguy]

i also have a minimag with level 10 upgrade,dye veritcal reg, everything else is stock, i have a slight problem of leaking on the velocity adjuster. i can only shoot 260 turning it up would cause to leak, i also notice that theres a metal washer in the velocity adjuster rather than an plastic o-ring ...

[PyRo]

First thing I would do it ditch the reg. Its useless on your classic valve. You might have a really horrible paint-barrel match with tons of porting. More likely you have a bad reg seat, that metal washer is doing somthing, or your spring pack or reg piston has gone bad.