View Full Version : Emag Valve to X Valve
abunkerer
09-23-2003, 05:50 PM
I just installed an X valve on my Emag, I took it out on the field and during high ROF it seemed to be short stroking every now and then...Should I have swapped the Emag on/off pin with the X-valve on off pin?
-the x valve was broken in and tuned on a mech. mag
anyone know if there is a difference in pin lenghts, has anyone else had this problem??
Dayspring
09-23-2003, 07:22 PM
Yes. YOu have to swap the on/off pin & assembly from the Emag valve to the Xvalve.
Xvalves should be around a .750 pin. Emag pins are .712 or .728 depending on how many orings are in the on/off hole.
abunkerer
09-23-2003, 07:50 PM
Thanks a lot for the info!
Now if I can just track down the guy I sold the valve to...
Tunaman
09-23-2003, 09:24 PM
If you cant find the dude, I have some pins if you need one. Email me.;) :D
Schnitzel
09-23-2003, 10:11 PM
you didnt mention the quad oring...did you remember to transfer that over too?
abunkerer
09-29-2003, 01:18 PM
swapped the pins o-rings, ect. Now it works awesome, the strings of paint shooting from that thing were unreal!
Spleen
09-29-2003, 01:29 PM
how long did it take you to break the valve in? i just got mine a while ago and put around 3 cases through it so far and havnt had to adjust anything yet.
abunkerer
09-30-2003, 06:31 PM
I put about 6 -7 cases through it, I havent had to adjust it too much after the first day,(switched to a smaller carrier, added 1 shim and swapped the spring from mid-length to the longest one)
Now I just keep it well oiled, and it works good
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.