rt pro not working

[gerry]

asking for help.. i have a rt pro set up wit an armagedon tank, an lvl10. when i gas the marker i hear the click of the valve and the trigger goes up. but when i pull the trigger nothing happen. i try everything with the lvl 10, different tanks, and no response, so i remove the lvl10 and install the original one. then nothing. what coul be the problem????

[Kevmaster]

when you install LX you need to increase the velocity to get hte marker to fire. make sure your LX is installed properly aswell (the carrier is not too tight).

[ß?µ£ §mµ®ƒ]

also which spring do you have in? weaker the spring less you have to turn up the velocity i think

[gerry]

theres no lvl-10 in the marker,

[PyRo]

Ok, your on-off is in correctly right, not that that would probably do this.
Have you messed with the trigger rod, shortening it will do exactly what you are describing.
I'm assuming you bought this used and it came with the problem?

[Kevmaster]

if you pull the trigger all the way forward, with the marker gassed up, the trigger rod (metal pin behind hte trigger) should stick out 1/16" behind the trigger. Make sure it is 1/16" away from the trigger. if not, turn it till it is that far

[gerry]

the gun is used,and it work with a pressure higher of 1000 because i didnt check the pressure of the tank, then i fixed and the gun stop working. all the orings ok. making test with 3 different hp tanks at 850 ps

[Kevmaster]

what did you fix on the marker?

[PyRo]

Is it me or can noone quite make out what he is trying to say?
Your gun works if you input more than 1000psi into it?

[gerry]

wht im trying to say its that it was working (1000psi) the i fix the pressure(850psi) and then the gun stop working. i thing the pressure blew or bend something

thanks for the help

[gerry]

about the question of the trigger--- i havent mess with the trigger

[cannibal ox]

you sound like a "gerry's kid"