Warp Feed..

[Carnage]

My warp isnt feeding when I shoot. I played around with my sensitivity and it still doesent turn >< >< ><, Help anyone ? Please =)

[TSalPaintball]

If you tap the side does it turn?

[PyRo]

Does it prime when you push the button? PTP or AGD warp? If its a PTP make sure its plugged in all the way, check for wires that got pulled off? Your sensor or board might be dead.

[Carnage]

Yes it works when I push the button, and yes All wires are connected good. No it doesent turn when I tap the sides. It's an AGD Warp Feed. It's just when I shoot it doesent even turn.

[ß?µ£ §mµ®ƒ]

Try turning that blue thingy (sensativity switch on your board)

[Kevmaster]

make sure the jumpers are on correctly that it reads the sensativity plate. check the 'all about warp feeds' post to get the exact location of the jumpers

[Carnage]

Alright guys here is where my jumpers are.. can you tell me where to place them and how to remove them =)? I think im missing some.. I only have 2! anyway thanks.. The o's are where my jumpers are placed.

First set:

0 0 0 0
o o 0 0


Second set:
0 0
0 0
o o

[BetaMax]

Check out the Warp Feed manual. According to your jumper settings, it is not configured to accept the signal from your marker, that is to say if you are using intelliframe or E/X-Mag.

If you are using the vibration sensor, then you need to increase the sensitivity to the point where the warp activates and then dial it back till it stops.

Check out the PDF file for all the information you need to know..

http://www.airgun.com/downloads/WarpInstructions.pdf