PDA

View Full Version : I Need Help Fast!!!!!!!!!!!!!!please Help!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!


MagMan4life
10-06-2003, 06:35 PM
problem fixed, thank you!!!
TSalPaintball
10-06-2003, 06:42 PM
If you hold the trigger down does it stop the leak?, alos the CO2 could be your problem, you could be freezing up the marker.
MagMan4life
10-06-2003, 06:44 PM
well the trigger is like stuck down and it like wont even move.
TSalPaintball
10-06-2003, 06:47 PM
Bolt stick? Try using something to push the bolt back with, that could be your problem.
MagMan4life
10-06-2003, 06:48 PM
ill try that, 1 sec
MagMan4life
10-06-2003, 06:50 PM
nope, its all the way back
TSalPaintball
10-06-2003, 06:51 PM
Are you sure you put the marker back to gether right?, alos check your powertube oring for ware.
MagMan4life
10-06-2003, 07:24 PM
i think i found the problem, i have the trigger piece in there but its not fitting, the top of the trigger is just getting jammed against the body, is the trigger thing suppose to go in the body?
TSalPaintball
10-06-2003, 07:29 PM
What do you mean by the trigger thing? The sear?
TSalPaintball
10-06-2003, 07:31 PM
Here this might help you out, click on the classic 68 manual.http://www.airgun.com/manual.shtml
arsonpaintball06
10-06-2003, 07:33 PM
i concure with tsal......or coulda messed up your reg. seat or on/off
MagMan4life
10-06-2003, 07:34 PM
yes, that does help me, i will be able to fix it now with time. thank you!ill reply if i need more help, thank you very much!
TSalPaintball
10-06-2003, 07:34 PM
Anytime fellow AOer!
MagMan4life
10-06-2003, 10:30 PM
ok, i got a new problem now, when i put the bolt on the valve, the bolt doesnt go all the way down, it seems to get stuck like 3 quarters of the way down, then i took it apart and when i take the power tube tip off it fits fine, then i put it back on and it doesnt work. but then i put the same power tube tip on my other mag and it works fine. i have no ****ing clue what is wronge. please help!!!!!!!!!!!
MagMan4life
10-06-2003, 10:36 PM
ok, nevermind, i got that problem fixed, i had one too many o-rings in the valve. my bad.now i just have to run the lines and it should work, wish me luck!
MagMan4life
10-07-2003, 05:19 PM
new problem,

the on/off pin keeps falling out of place and its jamming the trigger.
MagMan4life
10-07-2003, 05:19 PM
and gas is comming out the front VERY VERY fast!!