milled pack

[detroit]

right side?

[detroit]

left

[edweird]

I think it would look better the other way... so the flames seem to be going to the rear.

the way it is now it gives the illusion of going backwards


**Edit** now that I see your left side... I just think the right panel is backwards. the left is fine... however I would considder hollowing out the inside of the flame area

[detroit]

last one

[Mossman]

thats sweet but the rail needs elongation.

[FreakBaller12]

very very detroit
i love it:D , how much is it going to cost me,

comments:i want both of the sides the flames going back, like on the left side, inside of flames have a deeper impression, other than that i love it!

pm me on the price

edit: yea light the rail up with flames. if you could;) :p :p :p

[ezrunner]

looks like he wrote the gcode to do this with a small cnc mill (maxnc, etc) and ran it with his batt pack in each side so that he only wrote one copy.

If this is the idea now great, lemme know and we can get together with a design that looks the same upside down so that you can have it look the same on each side....i'll try to do a pic later.

-rob

[detroit]

i use smartcam we have a lot of cnc stuff here mostly big stuff

[RoadDawg]

The left side looks alright IMO. It would look better if it was a fire color. That and your rail is bugging the snot out of me. How deep are the cuts if you don't mind me asking?

[FreakBaller12]

i am doing soemthign sweet with ym gun you'll see

[angelbeast24]

that is that gayest thing i haev ever seen yah lets make our gun look flameing the only cool gun with flames is the kapp flame trix