sympathyforthedevil
10-19-2003, 07:00 PM
Never used one of these threads, but if it works, I figure you all would know about everything about this. Here goes: I've decided after ow so much deliberation to get a Mag, now it is a matter of which one and how to configure it... I am going to appologize now for not knowing a hill of beans about the extent of the design, so forgive me if I say some dumb sh*# and don't know what Im talking about, because I don't.... I initially thought about just getting a Classic and upgrading it... then I talked to a few people and figured I'd get an RT Pro and I'd be good to go... then I looked into it further and began compiling a list of the options and found even with a Pro I would want to reconfigure it, and in the process replace almost the whole gun.... so here is what I came up with, and here is my question: I would like to use a ULE body (Warp Feed, left side), get an X-valve, put on a Y-frame grip, wire it for Intellifeed, and wrap it up by bolting on one of the rails... can this be done? What else am I going to need? If I can combine all of these pieces, which ones should I order (specify them all for an RT Pro, and use a Pro rail, or get the ones all for a Classic configuration?) Is it better to get everything in the Pro set-up, and will it allow me to get the new trigger pull kit? Is this combo even possible, and what else will I need to make it work? It seems that the Mag concept is a component system, so can it be built with all of the aformentioned items, or is there some facets of it's buildup I am utterly failing to understand? Any and all information you could offer would be greatly appreciated in helping me realize my Dream Mag.