ciscokid
10-22-2003, 01:43 AM
I recently install a level 10 in my e-mag and i think i scweded something up, also i put in another magnet on the trigger to make it pull a little better.
Anyway at first it was only on e-mode that it would not fire correctly when i gas it up....if i did not gas it up i can here the trigger firing correctly in 1,3 and 6 round burst but as soon as i gas it up the sear seem's to not want to perform properly it sits low behind the triggger if i raise it, it starts firing correctly but with me holding the sear up higher on the back of the trigger with an allen wrench...also i messed with the switch that turns it into manual mode or e-mode (the screw was a little loose) and now it clicks into position in the wrong location and will not allow it to be in either mode ive tried backing it out put with no real result--ive got it to do manual but its in the wrong position and e-mode has never come back on.
Any help would be greatly appreciated.
cisco:cool:
Anyway at first it was only on e-mode that it would not fire correctly when i gas it up....if i did not gas it up i can here the trigger firing correctly in 1,3 and 6 round burst but as soon as i gas it up the sear seem's to not want to perform properly it sits low behind the triggger if i raise it, it starts firing correctly but with me holding the sear up higher on the back of the trigger with an allen wrench...also i messed with the switch that turns it into manual mode or e-mode (the screw was a little loose) and now it clicks into position in the wrong location and will not allow it to be in either mode ive tried backing it out put with no real result--ive got it to do manual but its in the wrong position and e-mode has never come back on.
Any help would be greatly appreciated.
cisco:cool: