PDA

View Full Version : **ULE--???????****


ciscokid
11-07-2003, 02:16 AM
Hey , would like to know if the barrel detent--(i think thats what its called?) has to to be unscrewed or pop out ,so th ule can sit flat on the rail,ive tried both and the thing will not move an inch...how did you guys do it?

cisco;)
PyRo
11-07-2003, 02:21 AM
It needs to be pressed out.
ciscokid
11-07-2003, 02:29 AM
Pyro
Ive tried,,,i even hit it with punch out and hammer(is it glued?) but was worried i would break something...so your saying keep at it?

cisco
PyRo
11-07-2003, 02:33 AM
I'm pretty damn sure it just takes alot of force to get it out. Howmuch I don'tknow, and how to do it witohut bending or breaking your rail (which you actually can do) I dont really know.
ciscokid
11-07-2003, 02:37 AM
Ya,, its the only thing i was worried about and was hoping somebody found an easy way to remove it....thanks for the response.ill keep tyring.


cisco
PyRo
11-07-2003, 02:56 AM
People have broken there rail in half before so be careful.
*-_ULE_-*
11-07-2003, 07:05 PM
take your trigger frame off, and im pretty sure on the bottom of your rail, theres a little allen screw, i think you just unscrew that and it pops out- that's what I did.
PyRo
11-07-2003, 07:07 PM
Really? I thought that that got the thing in the middle of it out, now the whole piece.
*-_ULE_-*
11-07-2003, 07:22 PM
you only need to get the middle part out- the outer part stays in
PyRo
11-07-2003, 07:23 PM
Damnit! I thought you were trying to get the whole thing out. Did you try unscrewing it yet?
ciscokid
11-12-2003, 01:03 AM
I tried unscrewing the out the bottom piece and yes the spring and piston come out put the brass body stays in place,only problem is it sticks up a 1/16th raising the ule up a little..i took pryo's advice and tried pushing it out..it turns out to be soft metal(copper) so its smashed flat on the rail now...i thinks its screwed up,,,but the ule sits flat on the rail now.

cisco:(
Dayspring
11-12-2003, 10:15 AM
Which way did you try pressing it out?

It comes out easily if you turn the rail upside down and whack it.
athomas
11-12-2003, 03:23 PM
If you flattened it against the inside of the rail, then you were pressing it the wrong way. It comes out the top of the rail. Place the rail upside down straddling a couple of blocks of wood. The bottom of the twist lock assembly will be sticking high out of the rail. Hit the bottom of the assembly with the hammer. It should force the assembly out the top of the rail between the blocks of wood.