riooso
11-21-2003, 11:41 PM
I have an RT Valve with an LX bolt setup. Normal setup of 1 or 1/2 carrier with one shim. I went through the normal sizing down of the carrier till I got to a 1 with no leaks. Then I started getting bolt stick replaced the bolt o-ring but had sticking problems. I noticed that both my 1 and 1/2 carriers have been destroyed by the bolt and are all bent up inside the carrier where the bolt would travel though. Is this normal? I probably have 150,000 cycles using either one of these carriers. Would appreciate some feedback. I don't care about the carriers but am worried about the valve.
Thanks,
Rio Oso
Thanks,
Rio Oso