PDA

View Full Version : E-Mag sear adjustments


Timmee
11-23-2003, 09:43 AM
Ok, when I recieved my E-Mag sear in the mail yesterday, I quickly found out that there was no form of loctite on any of the threaded rods. I need to know what the lengths of both rods are, in order for it to work correctly. Also, is blue loctite strong enough to hold the adjustments, or will I have to get red loctite for it? Any help would be appreciated.
ChucktheMAGician
11-23-2003, 03:22 PM
Originally posted by BlackVCG
E-Mag:

Trigger Rod: 2.125"

Solenoid Plunger Rod: 3.005"


I'm not sure about the blue loctite question, I would think so tho.
Timmee
11-23-2003, 03:51 PM
Originally posted by ChucktheMAGician

I'm not sure about the blue loctite question, I would think so tho.

Where do I take the measurements from, though? IIRC, one end is the clevis axle (but I'm not sure), but on the E-Mag plunger rod, where do I measure to? The rod isn't long enough, so do I measure to the end of the plunger?