View Full Version : ULE warp to e-mag
coolcatpete
11-25-2003, 09:26 PM
I was wondering if I have to make any mody to my stock e-mag rail for a warp ule body. Is there a different rail that alredy has this done to it that fits the e-mag.
Thanks Pete.
jayel579
11-25-2003, 09:32 PM
nope, all youll have to do is remove the twist lock pin from the rail.
maglover52
11-25-2003, 09:32 PM
yeah you would have to mill out the side for it to fit. rougefactor can do it for you. or im sure u could buy a rougerail and just have him mill that out for yeah.
coolcatpete
11-25-2003, 09:42 PM
I did not know rouge made a rail for the e-mag, does any one have pics of their warp ule on an e-mag.
Pete.
Burphel
11-26-2003, 04:57 AM
Well, you don't *really* need to have it milled or a new rail. It's not a big chunk, so if you're good with a Dremel tool, it can be done that way without problems. Mine was done this way and you have to be looking very close to tell it isn't stock.
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.