will the 90* elbow from the warp work with my Ule warpfeed mainbody?

[stalker0]

or do i have to get something special?

[stalker0]

becuz i think i cut to much tubing.

[cphilip]

You would be better off just getting some more tubing. It always works best to eliminate any 90 degree bends. If you can. And make all changes in direction as subtle and smooth as you can. Its a flow thing. A 90 will work but its not optimal. No sense having the right body and then cobbling it up to eliminate the advantage that it was supposed to give you. Get some more tubing. And this time cut a little at a time.

[sneakyhacker420]

get the PTP warp hose and connect the top adapter directly to the warp ULE neck


ptp warp hose = feeds no matter what - even tied in a knot!

it has a SS spring/wire woven into it so it can't be crushed... it streteches up to 2x its length too!

www.proteamdirect.com


i bought 2 feet and love it to death!!

[personman]

Contact Rogue Factor here on AO about his ULE Body warp adapters. They will replace your feedneck and allow the 90* to clamp on. It looks very clean :)