View Full Version : Machinist Question Cocker threading
eskimo
12-04-2003, 12:21 AM
Does anyone know the threading on the front block screw, and the thread sizes on the rods? I think I may have to have them re-tapped.
Thanks in advance
sniper1rfa
12-04-2003, 08:28 AM
the rods are 6-32, the frontblock is 9/16-24 via the ratsnest (http://haveblue.org/tech/)
If they're stripped you may not be able to re-tap them. You might have to use a "hela-coil". (sp).
Sorry, can't help you with thread sizes, I don't have one to measure. You might take the rod to your local hardware store and use their thread guage.... ;)
EDIT: you beat me sniper!
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.