e-mag frame disassembly

[headcase]

OK, I am in the process of breaking down my E-mag frame for anno. I have it all apart except for one piece, on the front of the frame, where the battery connects there is what looks like a pin with a semi-dome on one end. How is this removed? Is it just a friction fit? If so what size punch do I need to remove it?

Thanks

[headcase]

Someone has to know

[[GIB]Spiff]

If your talking about the barrel detent (it has a spring loaded rounded tip), it is a press fit. I had to remove it to get my ULE body to fit. If I remember correctly (which is always suspect). Just use a punch that fits the bottom, even an old socket will do. Drive it out from the bottom to the top. HTH.

[headcase]

Thanks for trying. The piece I am talking about is on the other side of the hole circled in the pic. I was told by Tuna that it is pressed in, and trying to remove it with out using said press would be difficult to say the least.

http://www2.freepichosting.com/Images/121826/0.jpg

[TheDuelist]

It just pulls out. It shouldn't be threaded in. When I did mine I carefully wedged a sharp knife under it and was able to work it out.

[Schnitzel]

if you can get a punch in there it should tap out no problem. use a nail if you cant get one in there small enough.

[headcase]

Thanks for the info guys.

[Aegis]

That is your negative post for the battery. As far as I can tell, it has a rounded head. Try to find a cup head punch to drive it out - a regular punch may deform the head. Haven't done it myself, but that would be my guess.

[xrancid_milkx]

Originally posted by headcase
http://www2.freepichosting.com/Images/121826/0.jpg

Is that an eye in there?

[headcase]

Originally posted by xrancid_milkx


Is that an eye in there?

Why yes it is. That is also the insperation for my E-mag project. There are a couple of good threads either in Tech, or the workshop with the info.