PDA

View Full Version : ACE 4 Emag?


PaintballSmurf13
12-24-2003, 12:52 AM
Hey, i was just looking in the parts section of the AGD online store and you can buy the ace. So would it be possible to install it on an Emag with a Chord body or something?

-Ryan F.
Dayspring
12-24-2003, 01:04 AM
You'd need to do some milling in the gripframe to fit it, as well as mill the body correctly so that the eye fits right.

Not a job for an amateur.
TransMan
12-24-2003, 01:12 AM
bah dont listen to him go get a dremel and cut away until it fits :D




JOKING dont do that listen to him
PaintballSmurf13
12-24-2003, 06:17 AM
so if i sent it to a custom gun kind of place it could be done?
BajaBoy
12-24-2003, 05:54 PM
Originally posted by PaintballSmurf13
so if i sent it to a custom gun kind of place it could be done?

i did mine myself, i dont think Any "custom" gun shop would do tha kind of work
magmonkey
12-24-2003, 05:59 PM
we would
and are ordering the parts to do one this coming week

Alan
Destructive Customs
Methylphenidate
12-24-2003, 06:06 PM
does any of the rail need to be milled as well or is it just the body that need milling
BajaBoy
12-24-2003, 06:07 PM
Originally posted by magmonkey
we would
and are ordering the parts to do one this coming week

Alan
Destructive Customs

lets see some of your work.. post it in the Workshop thread
Dayspring
12-24-2003, 06:14 PM
Yes. It needs to get milled.


Originally posted by Methylphenidate
does any of the rail need to be milled as well or is it just the body that need milling
RRfireblade
12-24-2003, 07:13 PM
http://www.automags.org/forums/showthread.php?s=&threadid=98796&highlight=aced+emag

http://www.automags.org/forums/showthread.php?s=&threadid=106944&highlight=aced+emag


That should give you an idea.

Not a MAJOR undertaking,but not a beginners project either.

Jay.
magmonkey
12-24-2003, 10:40 PM
http://www.automags.org/forums/showthread.php?s=&threadid=95096&highlight=raw+viking+fun

http://www.automags.org/forums/showthread.php?s=&threadid=89855&highlight=worlds+cheapest+cocker


http://www.automags.org/forums/showthread.php?s=&threadid=88222&highlight=pump+slot+milling


http://www.automags.org/forums/showthread.php?s=&threadid=113878


http://www.automags.org/forums/showthread.php?s=&threadid=87491


http://www.automags.org/forums/showthread.php?s=&threadid=92710