andrewnelles
12-29-2003, 05:51 PM
The Lvl10 has been working great on my emag, but now its not doing so well
My current set up is
Xvalve
3 Shims
1 line Carrier
Red (medium) spring
However with this set up i cant get it below 280fps now. Yes its freshly lubed.
I tried going to a carrier 1 dot wider, but then it leaks slightly.
If i go to the original spring it gets below 280fps but the bolt hits forward way to hard. Any suggestions?
My current set up is
Xvalve
3 Shims
1 line Carrier
Red (medium) spring
However with this set up i cant get it below 280fps now. Yes its freshly lubed.
I tried going to a carrier 1 dot wider, but then it leaks slightly.
If i go to the original spring it gets below 280fps but the bolt hits forward way to hard. Any suggestions?