View Full Version : trigger pull?
TheDoveDecends
01-03-2004, 04:02 PM
Is there anything you can do to make the trigger pull on a Benchmark double trigger frame lighter / shorter??
RRfireblade
01-03-2004, 04:07 PM
On ANY mag it's lighter and longer OR heavier and shorter.(excluding ULT on/off which is lighter@ about the same length)
So basically...no.
Jay.
TheDoveDecends
01-03-2004, 04:15 PM
yeah but the benchy's heavy AND long. lol
RRfireblade
01-03-2004, 04:21 PM
Not compared to an Intelli.
The Benchy is one of the lighter trigger pulls but also one of the longer.On a Mag,all the trigger does is increase or decrease the leverage on the sear.If you increase(Benchy),the pull gets longer and lighter,if you decrease(intelli,Dye),it gets shorter and harder.You could put a ULE on/off assembly in and then change the pivot point of the trigger rod on the sear which would lighten it and shorten it but that takes a little handy work.
Jay.
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.