Bad_Dog
01-04-2004, 12:35 AM
I did a search on this topic and it came up nonconclusive so I apologise if I am recreating someone elses thread.
some of us AOers are trying to design a replacement for the 90* elbow that is used to link the warp hose to the warp ule body. In doing this we have come up with a few ideas, some good, some bad, but the help of knowing the actual specifications of the warp body... would be greatly appreciated.
The specs that were looking for would be mainley around the feed neck area, like the inner and outer diameter of the feed neck itself. The length of the feed neck, would also be of great use, and does anybody know if the feedneck is threaded into the warp body, or is it all machined from one piece?
Any help on the topic will be awesome! thanks in advance!:)
some of us AOers are trying to design a replacement for the 90* elbow that is used to link the warp hose to the warp ule body. In doing this we have come up with a few ideas, some good, some bad, but the help of knowing the actual specifications of the warp body... would be greatly appreciated.
The specs that were looking for would be mainley around the feed neck area, like the inner and outer diameter of the feed neck itself. The length of the feed neck, would also be of great use, and does anybody know if the feedneck is threaded into the warp body, or is it all machined from one piece?
Any help on the topic will be awesome! thanks in advance!:)