Warping a WorrBladed Cocker???

[Wierd-Guy]

What equitment do I need? Where can I buy? Any concerns I should know about?

[~WarpedRT#2~]

Well, you will need a 90 degree elbow, and alot of hose, about 8 inches just to make sure you have enough. I warped a cocker back when my RT was being fixed, and I had to use a friends gun. Cyberious also had a warped cocker. They seem to run fine on them, but with the warp, and the fact that I was always worried about the back block hitting me in the face, it just felt clunky, you of course, may feel different. Let me know how it goes.

Also, what do you need to buy? The warp or the gun? I'm assuming th warp, so the online store has them, and i know they have been going for $100 now. And You can find the 90 degree elbow in the store somewhere i'll bet.

[Wierd-Guy]

I shot one on sunday and it was Intellifed to the electronics, how do you do that?

[Zygote]

http://www.airgun.com/downloads/intelliwarp.pdf

It will be a bit different since you're using a cocker but there it is basically.

[Wierd-Guy]

The one I shot was Intelled to the 3-Way wire in the grip. The guy said AGD made it specificly and retailed for $15.

[kenndogg]

go to www.moodypaintball.com and get ahold of Nathan. He can intellifeed your warp to the cocker.

[Python14]

Wasn't there a warp body out for a while? I think that would be kinda neat.

[Wierd-Guy]

up