PDA

View Full Version : My gun does not shoot in electric after the first shot



blakdragon21
01-06-2004, 12:53 AM
My gun does not shoot in electrice after the first shot? what should I do? It shoots in manual fine, but if i turn it to electric it shoots one shot then the electric dies on me. What is going on here?

rikkter
01-06-2004, 08:19 AM
is the battery charged?

blakdragon21
01-06-2004, 01:28 PM
yeah the battery has a charge. Also when I push the buttons in back the screen glithces and flashes but I can't read what it is saying.

nerobro
01-06-2004, 08:51 PM
sounds like you need to have your board replaced/reflashed. I'd call AGD and get a RMA number and send that puppy in.

Branchvillian
01-06-2004, 08:54 PM
You could need your ground screw re-tapped. The board doesn't have to move around much to flash on and off, which would explain why your marker isn't shooting.

ChucktheMAGician
01-06-2004, 09:18 PM
Have you tried adjusting your trigger lately? If the magnet is to close to the HES it will screw things up greatly. I'd back that magnet out a bit and cut the gun on and see how it does.;)

Branchvillian
01-06-2004, 09:48 PM
That could be it, but I honestly think his ground screw needs to be re-tapped. This same thing happened to me E-Mag when I first got it.

Blackdragon-Take off your grips, and just push your led screen down EASILY on the sides, wiggle it around a little bit, you will probably get it to flash on and off.

blakdragon21
01-06-2004, 10:31 PM
Thanks for the info guys, but it still does not work. I think I might have to do with the HES as one of you talked about, cause the screen is fine if I do not shoot it but gets mest up after I shoot it and and the gun wil not fire again. THe problem is I have NO clue what the HES is or where it is at. I do not know how to adjust it or my trigger can someone help me plz. thanks

ChucktheMAGician
01-06-2004, 10:39 PM
The little hole in the middle of the trigger adjusts how close the magnet on the back of the trigger is to the HES, in the frame behind that little black panel. Stick a 1/16" allen wrench in the hole on the trigger an unscrew.

blakdragon21
01-06-2004, 11:13 PM
what do you mean by unscrew? like all the way out?

Branchvillian
01-06-2004, 11:23 PM
No, very small turns. It doesn't take much to get it fireing again.