Cha0tic
09-08-2001, 05:16 PM
ok, i am testing the effects of molding your paddles in your 12v revvy so that they do not hit the side of the revvy. this can be done by heating them and then bending the paddles up.
anyways, i loaded my hopper up with about 200 balls. i turned the revvy on and then let the balls fall out for exactly 10 seconds. i did this expiriment 3 times and concluded that i was feeding an average of 13.6bps.
can someone repeat this expriment with an unmodded revvy? i would like to know the differenced between revvies that have the paddles folded up off the side and stock revvies.
anyways, i loaded my hopper up with about 200 balls. i turned the revvy on and then let the balls fall out for exactly 10 seconds. i did this expiriment 3 times and concluded that i was feeding an average of 13.6bps.
can someone repeat this expriment with an unmodded revvy? i would like to know the differenced between revvies that have the paddles folded up off the side and stock revvies.