WhataSpaz
09-14-2001, 09:43 PM
I recently purchased the new bolt kit for the Matrix. Well along with redesigning all the parts they also redesigned the chip.
On the stock board that ships from Diablo I was able to use the link cable perfectly. The warp will cycle for about 2 sec. with every pull, but once I installed the new chip I found that the warp stays on a min. of 8 sec. no matter how many jumpers I use.
On the stock chip I was using the top left pin for "+" and the top right pin for "-".
If anyone can help I would greatly appreciate it.
Thanks,
Dan
On the stock board that ships from Diablo I was able to use the link cable perfectly. The warp will cycle for about 2 sec. with every pull, but once I installed the new chip I found that the warp stays on a min. of 8 sec. no matter how many jumpers I use.
On the stock chip I was using the top left pin for "+" and the top right pin for "-".
If anyone can help I would greatly appreciate it.
Thanks,
Dan