what's a good upgrade for the RT PRO? does intelliframe fit this gun?

[rtpro28]

trying to build a descent custom rt pro, any good ideas on upgrades? I wan't to buy the intelliframe but heard it might not fit the rt pro. and how easy is it to install?
Any info would really be appriciated. thanks

[nippinout]

If you don't have it, LVL10.

Then ULT.

LVL10 rules.

[rtpro28]

yeah thought about the level ten, what do you think about the intelliframe.

[Miscue]

The Intelliframe fits an RT Pro just fine.

[nippinout]

Intelliframe is metal. Therefore, it rocks. :D I like my Intelliframe. Don't have it hooked up to my loader, but the trigger isn't sloppy or anything. I'm happy.

LVL10 should be the first though. RT Pro was outshooting my VL-2000 all the time.

[rtpro28]

when installing the intelliframe do you just take out the field strip screw behind the trigger frame and the screw in front? do have to mess with the sear or trigger rod at all.
hey sorry i'm asking stupid questions. i'm still not too familiar with my gun yet, and thanks for the help!!!

[dyeforever]

NO!! do not touch the trigger rod. i repeat do not rouch the trigger rod.

it factory set to fit all AGD trigger frames

[FragTek]

I have just the ticket for ya!

http://www.automags.org/forums/showthread.php?s=&threadid=122696

Check there and see what you might want to put together... Build it up with RogueFactor's custom parts and have the nicest RT on the field. Get ahold of me if it's something you are interested in. Thanks!

[Mag_SEAL-6]

Intelliframe is very easy to put on. Simply unscrew the screw in the back of the grip frame. This unhooks the valve, so slide the valve out (or leave it in, doesn't matter). Then take an allen wrench and unscrew the allen screw in the front of the grip frame. There's a hole in the trigger guard for you to use the longer side of the allen wrench to take out the allen screw. Then slide the i frame straight off, carefull not to bend sear. To put back on, slide sear in the slot behind the trigger (you'll see it poke out right up against the back of the trigger). Then put the screws back in. Put the back screw in finger-tight. Hope that helps

[rtpro28]

yep, thanks alot