oh my god my xmag wont work!

[tmnothing]

My xmag wont work in electronic or hybrid mode. It fires in mech mode but when I switch the power on for electro a few pixels flash on the screen and then nothing will come up on the screen. If I turn off then on again pixels flash again but nothing happens. If I unplug the plug from the board with the 3 wires (yellow, red, black) that's the second one from the bottom the screen will power on and I can maneuver through the menus. I havn't assembled the gun to see if it will shoot with that unplugged. What happened! How do I fix it!?

-AK

[Remington]

Are you sure the battery is fully charged? Also, try backing your trigger out alittle bit, you may have it in too close and the magnet could be affecting the HES sensor. Good luck! :D

[Dayspring]

Yup. Trigger magnet is too close to the HES. back it out and it'll work fine.

[tmnothing]

Phew. Thanks guys, that was scary. It was the magnet in the trigger.