How do i hook up revvy to iframe w/out warp board?

[Flip540]

like the subject says...
thanks

[Ityl]

I was just gonna post the same subject, except not intelliframe here, just a microswitch put in another frame. I think these kinds of things should be put on another page in the site, sry webbie, but it would be very helpful. Thanks.

[Flip540]

up

[Tunaman]

OK..in laymans terms, you need to install the switch in between the 2 wires that go to the sensor in the revvy. You can remove the eye(sensor), or leave it hooked up.