Warp question

[Gabriel]

Hey, I always heard warps feed at 20 bps, but checking out the AGD website it says 12 bps. Which is true?

Gabe

[Onryou]

I'm not sure of exact numbers but i know that my warp definately seemed to feed faster after I did the 12 volt mod on it. So perhaps its 12 on a 9 volt and 20 with the 12 volt mod...

[personman]

Warps defentally feed faster than 12 bps. I would say maybe around 16-18 bps, but I dont know about exact numbers.

[TSalPaintball]

It feeds much faster than 12bps. It was constantly being starved from my 12v Revy with X-board. I would say around 16-18 also.

[nt2004]

iit has something to do with the battery usage. I'm not exactly sure but i think it had something to do with a 12 volt adapter. If you run it on a single 9 volt then it feeds slower that if you use 2 9 volts.

[TSalPaintball]

Yes, PTP (Pro Team Products) makes a 12v adapter for the Warp Feed.

[Onryou]

or you can go spend $8 at radio shack and maybe 20 minutes of your time to convert it from 9 volt to 12 volt on your own.

[Gabriel]

Ok, 12 v mod sounds good


Originally posted by TSalPaintball
It feeds much faster than 12bps. It was constantly being starved from my 12v Revy with X-board. I would say around 16-18 also.

^^^what happens when it gets 'starved'? Does the warp not confinsate (sp?) for that?

[TSalPaintball]

It just will have moments in time will it will not feed any paint, than when the Revy catches up it will start feeding again.

[Beemer]

Originally posted by Gabriel
Ok, 12 v mod sounds good



^^^what happens when it gets 'starved'? Does the warp not confinsate (sp?) for that?


If you starve the warp you can compensate by pushing the little white primer button. Easy enough and works like a charm.

[angelbeast24]

a 9vt mod will feed bout 16 a 12vt mod will get bout 20