Need some help with my mag

[evan123]

So when i end up going to TeX-Ball I bring my one and only gun along. Specs in sig. I air up the gun and there is a strong leak from the inside of the valve. I ended up oiling the the bolt on/off and a lot of the valve and clean it as well. The leak goes down after i fire a few shots and now the valve has consistency problems where the balls fly in different directions and i dont know how to fix the inconsistency tomorrow. Can you all help me?

[ChucktheMAGician]

Do/did you have good paint? You were at a feild so I'm assuming you had it chrono'd under 300fps. Bad paint and shooting at to high of a velocity can cause screwy shots too.

[evan123]

It was brand new Draxxus, the shots were skipping around from like 210 260 290. It never got over 300.

[Cthulhu]

Check your reg-seat.

[rtpro28]

make sure you get all that excess oil out of your gun. too high of a velocity will screw up your ball and too much oil in the gun will do the same.

[evan123]

I didnt oil my gun to much. Just the on/off bolt and the two holes in the valve. I checked my reg seat and it still leaks. I dont have a chrono to tell my velocity right now which is a pain.