Biggest Complaint of the INTELLIFRAME!

[magman007]

NO HOLE FOR THE ALLEN WRENCH!!!!! NOOOOOOO it is horrible!, every time i want to tahe the gun apart it takes me an extra 5 mins to get the frame off and on! Tom for future reference please tap the frames for a hole!!!!

[Flip540]

isnt it like that with all aftermarket frames?

[mikey101]

ahh, its not that big of a deal, id rather have an intelliframe with no hole, then no intelliframe at all!:) It does take longer, but not that much.

[Thordic]

If you care that much, whip out the power drill...

[FaSSt]

I would have to work VERY SLOW to avoid scratching that frame. It was downright vexing! ;)

Seriously though, that frame IS sweet, but there should be a hole. It should be very easy to drill in the machineshop on a jig.

[Gunga]

I agree...definitely need the hole for the allen wrench. Makes it a lot easier to strip the gun.

[Flamebo]

Agreed, all new frames should be drilled.

[zads27]

Well what I do (not on intelliframe, but other non drilled frames) is used the magical ball-end hex screwdrivers. they basically allow you to take out hex screws at angles. Good little toy to have.

[PyRo]

What are your talking about? You only need the allen wrench for about one twist, then you can take it out with your finger. It takes me all of 20 seconts to take that screw out with my z-grip, which has no hole.

[Magsrule3]

Are you guys talking about the front frame screw?

[Dubstar112]

havent had a problem with mine yet, i just undo the front screw wiht my fingers after i tiwst it with the allen wrench

[DarkPhoenix]

I have to agree with zads27, a ball-allen set is something very usefull to have.