Gunga
09-21-2001, 08:22 PM
Just picked up my Intelliframe from the factory today so I could play with it this weekend. Marsha and Joanne are as nice as their reputations, BTW. :)
Anyway, after I installed the Intelliframe onto my Mag, I was attaching my Shocktech drop forward. Lo and behold, the screw holes in the IF weren't tapped deep enough, and there was quite a bit of slop. I was using screws that came with my bottomline adapter that worked perfectly with the stock Mag triggerframe.
I ended up stripping out a few threads from one hole as I cranked on it a bit, expecting there to be more depth into which to screw into.
I went to Home Depot and bought a couple washers (approx 1/8" thick) to serve as spacers. Not a big expense (a whopping $ 0.04), but a definite hassle.
Tom, do the Intelliframes require the use of shorter than standard screws to attach a drop forward? If so, mine didn't come with any. I called AGD's tech support and the fellow I spoke with wasn't aware of any special sized screws, if that indeed is the case.
It just might be that my particular Intelliframe has this defect. I'm not trying to flame Airgun Designs, I'm just trying to let them know of a possible defect that is easily fixable by whomever makes the Intelliframes for them.
Anyway, after I installed the Intelliframe onto my Mag, I was attaching my Shocktech drop forward. Lo and behold, the screw holes in the IF weren't tapped deep enough, and there was quite a bit of slop. I was using screws that came with my bottomline adapter that worked perfectly with the stock Mag triggerframe.
I ended up stripping out a few threads from one hole as I cranked on it a bit, expecting there to be more depth into which to screw into.
I went to Home Depot and bought a couple washers (approx 1/8" thick) to serve as spacers. Not a big expense (a whopping $ 0.04), but a definite hassle.
Tom, do the Intelliframes require the use of shorter than standard screws to attach a drop forward? If so, mine didn't come with any. I called AGD's tech support and the fellow I spoke with wasn't aware of any special sized screws, if that indeed is the case.
It just might be that my particular Intelliframe has this defect. I'm not trying to flame Airgun Designs, I'm just trying to let them know of a possible defect that is easily fixable by whomever makes the Intelliframes for them.