alf
09-22-2001, 02:51 PM
Alright,
not sure what this piece (pieces, actually) is called, but it is between the two pieces of the Retro valve...in the same location as the automag's reg seat. consists of an O ring, a small metal dome-shaped, cross-cut piece, and another o-ring...
when i took it apart, the outermost o-ring was partially out of the domed piece. should it fit snugly inside of it?
also, the on/off pin...can i just pull it out? when i took the on/off top/bottom piece out, the pin stayed in the valve
(never took a Retro valve apart before, and dont wanna screw it up)
thanks again, guys
-alf
not sure what this piece (pieces, actually) is called, but it is between the two pieces of the Retro valve...in the same location as the automag's reg seat. consists of an O ring, a small metal dome-shaped, cross-cut piece, and another o-ring...
when i took it apart, the outermost o-ring was partially out of the domed piece. should it fit snugly inside of it?
also, the on/off pin...can i just pull it out? when i took the on/off top/bottom piece out, the pin stayed in the valve
(never took a Retro valve apart before, and dont wanna screw it up)
thanks again, guys
-alf