Lvl 10 Bolt Problem! Please Look!

[Intellimag]

Ok, I installed everything and put the bolt on my valve with the original spring like the directions said.But then when I slide my valve with the bolt on it in the gun, the front of the bolt wont go past a certain point in my gun's body. It stops right at the circle inside it and the bolt wont slide any farther. It stops at the point on the bolt where it seems to be wider. I have no idea what to do. Is this a factory problem or is it my gun? I believe this has been asked before but I cat find the thread. Do I have to buy a whole new body? I am very ticked off about this. :mad:

[Dayspring]

You may need to take a file to the retainer ring in the body. Might have developed a burr that's catching on the bolt.

[Intellimag]

Man, that sucks, does this happen alot? and How would something like that form? And what do ou recomend I file it with?

[Dayspring]

Sometimes it just happens. Use of the older bolt, age, whatever...

And a metal file will work just fine.