PT enforcer trouble

[minimagjim]

hey there i need some help with my pt enforcers. I got two of them and they are both either not sealing right or are leaking. I had them disassebled for a while trying to figure it out. I dont know whats up that i can fix. I put them together correctly, so i am guessing its a internal thing, perhaps a o-ring or somethin. im not sure so if anyone can help that would be great. if i need to take them into a shop how much would that run me?? is it worth it?

Other than that i was wondering, if i should keep them or go for something else. I like the pistols for scenario or woodsball games, where mobility and stealth are needed over firepower. What is a good durable pistol that wont break down, i mean i have two PT's and both are down, thats not encouraging. Also if i were to get rid of the pistols anyone interested in them as is or if i repaired them, they wont be much since i really dont use them too often and i would rather see someone else using them...thanks

[yaddatrance]

Did you clean and oil your valve and cup seal?
If you take your trigger frame off and remove
the bolt and springs, look under the gun, there
is a brass screw. Remove that screw and then
using a straight rod, pop the valve assembly out
from behind the gun. Unscrew the two halves,
and clean the cup seal and the seat.

The CO2 out of a cracker is extremely dirty and
will cause your cupseal to leak, regular cleanings
will help prevent this.

If it is still unsalvagable, call 32 degrees and
they will usually send a replacement part.

I recommend the zeus 2 as one of the best semi
markers (which you can holster, the sydarm is
a bit unwieldy)