View Full Version : Emag intellifeed?
raider_o1
09-26-2001, 09:56 AM
I was to the understanding that the E-mag would come with an actuator for the Warp Feed. Searching my stuff I do not find a connector kit. Is there a set of connecting wires (kit) from the circuit board on the E-mag to the Warp Feed?
BlackVCG
09-26-2001, 02:03 PM
There's an interlink cable you can get from AGD. Call them and give them your serial number to your E-Mag and they'll send you the interlink cable at no charge.
raider_o1
09-27-2001, 12:59 PM
nt
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.