emag valve issue

[Snooky]

I can't seem to get my emag valve out even after trying to pull the trigger to release the on/off. I end up having to take the rail off to get it to come out. Anyone know what causes this and what the solution(s) could be?

[Skywalker]

I use to have the same problem, but I could never figure out what was wrong. I would just keep messing around with it and hopefully it will pop out.

[Tunaman]

always put the marker in manual mode and pull the trigger to remove the valve. You must push the on/off pin up first or it wont't come out.;)

[RRfireblade]

Also,depending on the trigger rod adjustment on some Emags,the sear won't completely depress the on/off pin in manual mode.

You can ramp the rail with a small file at the rear of the on/off milling to allow the valve to be pulled in that occasion.