Used Emag need help

[automag_20]

I bought a used emag and have been playing with it for a couple of months with no problems.

I gassed her up the other day to make sure she was runnin before a game and whenever I touched the trigger it would bounce reeeeaaaalllll bad. Then when I turned the electronics off and the gun was just sitting there it just started shooting a mile a minute. I have a 70ci 4500psi WGP tank on it and whenever I leave it sitting gassed up it just starts shooting.

I need your help guys what do I do.

[RRfireblade]

What pressure is the tank outputting?

[automag_20]

800

[RRfireblade]

Can you verify that with a gauge?

My initial guess is that your tank reg is creeping.

[automag_20]

It cant be the tank because I used my friends adjustable tank and it still does the same thing. It has to be the gun itself. Im guessing it is the solenoid but Im not sure.

[RRfireblade]

You said it'll go full auto,just sitting there,even with the electronics off,is that correct?

That should eliminate the soleniod and the electronics.

All that's left pretty much is either a too short on/off pin(perhaps it's simply worn)or perhaps stiction of the on/off pin not allowing it to fully reset or a badly worn sear.

IMO.

[Dayspring]

Yeah, we had a gun like that. The moment you put air through it w/o even turning the gun itself on, it would fire f/a. Turns out he snapped off the bottom of his on/off pin. It was so short it didn't even go all the way through the on/off assembly.

My guess is that you tried taking the valve out one too many times w/o pulling the trigger first to get the pin out of the way. Snapped the little bit off.

[automag_20]

Alright cool thanks now how do i fix that. Should i just send it to agd and have them fix it or can it be fixed without there help and not risk any more damage.

[ghideon]

On off pins are easily replaceable. If you de-gas the gun, remove the valve, and then look at the bottom of the valve for a brass squarish piece, and take that out, you'll see the on off pin in there (wow, really bad run-on there).

I can only find the RT on/off pin in the AGD store. Are the RT pins the same length as the E Mag pins?

[RRfireblade]

No.

Emags are .712 w/ the brass on/off top
.725 w/ the Aluminum on/off top

R/T's are .750 R/T Pros .765

[RenagadeOfFunk]

See your problem is... you mixed WGP with AGD :)

all you all know it ;):cool:

[automag_20]

Originally posted by RenagadeOfFunkRTPcf
See your problem is... you mixed WGP with AGD :)

all you all know it ;):cool:

Yah I know the tank was really cheap though. Cant pass up a good deal.

[automag_20]

Anyone know where i can get this pin. I cant find it on agd's website. I see what you guys are talking about though it wasnt even close to sticking out.

[ghideon]

You can always call em. I browsed for the E-Mag on off pin and couldn't find it.

Give em a ring and they'll be able to set you up.