BlackHalo
03-27-2004, 01:11 PM
I was thinking of getting a Z-Grip annoed and I had a few questions.
There is this little metal part in the sear area -
http://www.imageshack.us/img1/2299/metal_part1.jpg
I can't tell if it's aluminum or not. Does anyone know anything about it?
Also, I know I have to tap out the trigger pin, but which side do I tap.
It's a classic-RT Z-grip, there is a brass(?) ring in there. Is it ok to leave this in or do I have to remove it.
How the heck to I get the safety out?
Thanks!
There is this little metal part in the sear area -
http://www.imageshack.us/img1/2299/metal_part1.jpg
I can't tell if it's aluminum or not. Does anyone know anything about it?
Also, I know I have to tap out the trigger pin, but which side do I tap.
It's a classic-RT Z-grip, there is a brass(?) ring in there. Is it ok to leave this in or do I have to remove it.
How the heck to I get the safety out?
Thanks!