who will ACE a trix?

[chunk_daddy]

ive got a trix and i wanna put eyes in it, who does it and how much does it cost?
-Doherty

[sneakyhacker420]

http://www.thematrixcenter.com/pc/viewPrd.asp?idproduct=197

[RT pRo AuToMaG]

Gen E, Dye, and TMC will do it. Send it to Gen E/Dye for LCD, TMC for LED. You can also pick up parts to do it yourself on matrixowner.com, but I advise not to if you do not know much about matrix electronics and bodies, because if you mess up, there is no possible way to buy a new body without getting a whole new gun.


www.genenow.com
www.dyeprecision.com
www.thematrixcenter.com
www.matrixowner.com

[felony]

i believe it is 250 and the above link is correct.

comes with a new board as well

dan

[speedyejl]

Just get the Parts from Doby and Zdsan it'll cost you all of $50 or so, not a hard install at all just drill out a single hole and tap it, very easy

[RT pRo AuToMaG]

Only thing about installing eyes yourself is that:

1) Doby's eyes are TMC style, which means it will only fit LED eye board and Tadao, not LCD.

2)If you drill a hole wrong, you are screwed, and you need to drill 2 holes for the eye wire and 2 hole for screws in the eye carrier (or you can use double sided tape instead of screwing in the eye carrier, either one works). But one mess up, and you need a new gun since bodies do not sell seperate.


Another thing, eye carriers are $40, Breech is $60, and Doby's eyes are $25.

[speedyejl]

Eh most people just put a screw in the dead air chamber and of course the hole through the noid area, but thats not too hard.

With these two holes even if you messed up it'd only be cosmetic, unless your an exceptional screw-up and decide to drill the eye wire through the live chamber or something of that nature.

[Eatem Alive]

just send it to gen-e, ask for brian. best service you'll ever get.

[Torbo]

isnt this gun on the way out anyway?

[chunk_daddy]

nope