View Full Version : Can you ACE a Mirco Emag?
Phobos
03-30-2004, 04:59 PM
Just wondering if you can ACE a Mirco Emag and if any would be willing to do it or know someone who could do it.
lord1234
03-30-2004, 05:12 PM
as an xmag owner...i must say..ace on a mag(with properly tuned level 10) is about as needed as flies on strawberry jam....don't waste your money. I have personally never turned my eye on..nor have i ever chopped.
RRfireblade
03-30-2004, 05:15 PM
Sure,you can ACE anything electronic.Your probably not putting an AGD ace board in there due to the extensive milling required on a "MICRO' mag.Your best bet would be like a Morlock board and eyes.Pretty costly though,but definately possible.
Jay.
Phobos
03-30-2004, 07:39 PM
Thank you both. I will probbly just invest the smaller amount of money make sure it has the LVL 10 and have Tunaman tune it. (Ihave tride to get one tuned before and neither I or any local pro-shops could get the dollar bill bounce.)
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.