View Full Version : Custom DevilMAG Rails
GA Devil
04-09-2004, 08:33 AM
Ok since Ive seen such a wide range of milling designs what would you rather see?
Plain no milling
Flame design
RRfireblade
04-09-2004, 08:38 AM
I'd like see a sketch or something of what you have in mind to able to give any kind of an opinion.
"Plain" and "Flame" leave quite a bit of interpretation. ;)
chasden
04-09-2004, 08:48 AM
I'd like to see a flame sculpted rail. Mags could use a little extra in the bling bling dept.
Cryer
04-09-2004, 08:55 AM
I was never too big on flame-anything...
What I would do personally, given the opportunity (and generous bank account) to buy this mod:
Get the thing with a Sluggo and stock rail, throw them at nicad and have him mill them into a dallara and cut Eye holes.
GA Devil
04-09-2004, 09:01 AM
I have a limited run of custom bodies being made as i stated before. If someone wants to use someone else's body though I just need to see it to make sure it will work with my set up and I have no problem doing that. I am already going to be doing 1 for 1 of nicads customers that wants my board and eyes now too. But the board only goes as a whole gun or upgraded gun. Will not sell board with an incomplete gun. Also stock rails arent as easy to come by anymore.
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.